Archive for Sam Maloof

Custom Furniture for an Executive Office – Case Study (Part 9) – The Finishing Process

Posted in Uncategorized with tags , , , , , , , , , , on June 29, 2011 by johnwiggers

When it comes to wood finishing the most critical part of the process is sanding and preparation. Doing this properly requires a great deal of care and patience, but seeing the end results makes the added effort totally worthwhile.

At various stages in the previous posts it was apparent that a great deal of sanding work was already being done during the actual woodwork.

The desk top in particular required considerable filing and sanding while fitting the mother-of-pearl.

Since East Indian Rosewood is a naturally oily wood, it is necessary to wet and brush the pores to remove excess build ups. Once the wood has thoroughly dried the fine sanding work can begin.

Starting with 120 grit sandpaper, the sanding progresses through ever finer stages until a 240 is used to remove marks left by the coarser papers.

After the sanding work is done multiple coats of protective finish can be applied. In his book “Sam Maloof – Woodworker” the late Sam Maloof provided a detailed recipe for his unique finish that combines tung oil, linseed oil and shredded bee’s wax. (Be forewarned that it will take a great deal of trial, error and experimentation to find the appropriate ratios between the oils and the wax. Everyone will have to find their own balance that works best for them.)

320 grit sandpaper is used between coats to progressively smooth the finish.

This is a view of the finished desk top.

A detail view of the desk top showing mother-of-pearl inlays.

This is the main exterior shell of the pop-up cabinet.

Check out the faux ivory inlays on the split shell of the Scotch Bar. These inlays literally “pop” in contrast with the Rosewood.

A detail view of the dovetailed drawer boxes.

This is the credenza top, showing one of the inlaid custom wood grommets we made. I challenged Kevin to find a piece of Rosewood that would match up with the pattern of the top, and then to cut it in such a way that it would align as closely as possible with the existing grain. As you can see: he nailed it (figuratively).

The base of the Scotch Bar will take a little longer to complete, since multiple applications of vinegar and iron solution are needed to sufficiently darken the wood. This mixture is one of the traditional ways of ebonizing wood, and time must be allowed for the wood to progressively darken.

Next: Custom Furniture for an Executive Office – (Part 10) – The Renovation Nears Completion